Discussion Locked

smiple peer/peer network slow to respond

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Win98 2nd edition has one map drive and two catured printers. When I right click on the network printer it takes 30 seconds before I get the drop down menu. The printer works, it just so slow to respond. The dell dimension 4100 will take the 30 seconds to shut down also. The computer will lock at a restart but does shut down. I've tried different NICs and have tested the wire. I downloaded microsoft shut down patch. The other computer is a win98 B and is fine.

6 replies

by llaw

If your peers computers are configured differently, e.g.

one configured with NetBUI only while the other with both Netbui and TCP/IP or the other way round.

One peer tries one protocol to reach the rest and failed because the other is not configured, then try to use the other... This timeout is the delay. Try to configure both using Netbui,(good for small network and better internet security) and see what happen.

I have my peer-to-peer working fine with 4 PCs, all using Netbui, binded to Client for MS service,(while my TCP/IP is not).

by itp

Thanks for the responds and yes I striped all protocols off and just add the one that I was going to try. Both netbeui and IP work the same (networks up but the properties of the printer are really slow) The problem computer is connect to the internet using a dialup adapter. Could the computer be looking to go out to the internet and when it doesn't find it, it looks locally for it?

by llaw

Well, I don't think going out to the internet is a delay, in fact, going ANYWHERE is a delay. I remember in NT once mentioned the sequent of the binding is the sequent of polling. So, if you know how to, reduce the unnecessary bindings, such as TCP/IP to Client Service(which can be handled by Netbeui)

Another possibilities is the Printer properties. Remember when you put a printer on Share, you are asked if you want to keep a copy of driver for your peer machines and you have to specify what other machines you have on the local net. When you call up these peer printer server, these driver are actually crossload to the client - takes time!

And, when you first use a printer from a peer client, you are asked if you want to install the printer driver locally so that you don't have to look up the printer server, if you install it locally, then the rendering is done locally, immediately without going out to crossload the printer driver. Printer driver is necessary for the client to figure out the properties such as font, paper trays, density, etc before it can start rendering and sending out.

Good luck.

by rmckelvey

Im not sure if this fits the discussion, but I hve a PC that as soon as we put a network adapter in takes 4-5 minutes to boot up. With network adapter out its fine and if we put two in it to share the DSL it wont boot at all.

Thanks

Roger

by itp

Thank you for repling to the Discussion. I found the answer. I found the w32.hllw.bymer virus. The Virus goes out through the network card and tries to find another host via TCP/IP. The Virus also effects the Shut down of the computer. Removing it solved all my problem.

Thank you all who replied
Brad

This discussion is closed to new replies.