Discussion Locked

Sysprep

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello.
I have a master machine with XP ready to clone. I down loaded the sysprep tool from MS, put it on a floppy and installed it on the master in it's own folder with all the files needed therein. But how do I get it to run. It's telling me "Entry point not found" something about my DLLs every time I try and to start it. Also I cannot locate the INF file either. I know i'm doing something wrong can you help. Thanx

3 replies

by sfc_gijoe

You can also get the sysprep files from the XP Pro disk(Support\Tools\Deploy.cab). Make sure you remove all 10 files from the CAB file and put them on C drive in a folder called Sysprep. First you will want to run a file in the sysprep folder called setupmgr.exe. That will walk you thru a setup to make it unique to your company and create an answer file. IMPORTANT: If you have a Volume Product License Key you can enter it in setup Manager. If not leave it blank and use the 25 digit code that should be on each computer. After you have created the setup file then run sysprep.exe. Make sure you pick No SID GEN and then click FACTORY. After about 45 seconds your computer will shut down. Use this hard drive to clone all the other computers. When you reboot it will ask for a 25 digit code and a computer name.

by cs

check if your XP Pro installation is XP SP1 or XP SP1a. you can check this by clicking start -> run. in the dialog box type 'winver' and press enter. the following windows will tell you the version of your installation. if it isn't XP SP1 you first have to install SP1 or SP1a. this is recommended for launching sysprep.exe.

This discussion is closed to new replies.