Discussion Locked

Tape device detected but not responding

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hardware:
Compaq Proliant ML350 Server.
Internal 20/40 GB DAT tape drive (Compaq SDT 9000)

Software:
NT4 with all current serivce packs.
MS SQL 2000

I run an NT backup using the Windows backup software each day and a separate SQL backup. Recently I get the following error message (out of the blue, by the way):

"A tape device has been detected, and the tape driver started. However, the tape device is not responding. Check that tape device power is on and cables are properly connected."

Here is what I have done (to no avail):
Checked connections: they were fine.
Compaq engineer came out and replaced the tape drive.
Compaq engineer rechecked cables.
I removed the device driver, downloaded replacement driver at HP site.
None of the above helped.
At boot up, the system recognizes the SCSI hard drives AND the tape device.
Start>Control Panel>Tape Devices: Device working properly.
But, when you go to run Backup, at the bottom of the screen it says "Initialising Hardware" and hangs for 5 minutes and then comes back with the error message mentioned above.

Any ideas? Arrrggghhhh!

7 replies

by jennifer.gardner

You should try to look at this one piece at a time. You have replaced the tape drive, and still receive the same error, so the problem can not be with the tape drive itself. You said that the technician checked the cables, but not if he actually replaced them. You may want to try new ribbon cables. If you're confident that the problem is not with the cables, then you should turn your attention to the SCSI controller. Do you have any other SCSI devices? Are they working properly? If you eliminate one possibility at a time, you hopefully won't go crazy trying to resolve this issue.

by tink56

This morning I opened up the case and blew out the dust bunnies. My confidence level with the inside of a box is not as high as it is with running the software. I really wasn't sure what to look for so I gave each ribbon connection a gentle push into its slot to make sure it was secure. Since I wasn't really sure what else to do I decided to call Compaq. I shut everything up, restarted the server and just for the heck of it started a tape backup. Guess what? It works. I'm disappointed the Compaq engineer didn't resolve this since he actually switched out the tape drive for a new one.

by joseph moore

You probably read through all of the same Technet articles I did on this, but I am gonna suggest this anyway.
Technet article 170522 talks about needing a firmware upgrade for the tape drive to be NT compatible.
Sounds like a good thing to me.

So, I suggest you upgrade the firmware on the tape drive to the latest version. See if that takes care of it.
Here is the URL to the TEchnet article:
http://support.microsoft.com/?kbid=170522

Compaq support can help you get a firmware upgrade. You did not mention about upgrading the firmware on the tape drive itself, so maybe it is a step you haven't tried.

hope this helps

by karpi

Hello,

you have mentioned a sql-server backup, how do you backup the databases? If you have installed another backup-programm, maybe the NT-Backup driver was overwritten, and NT-Backup can't access the drive with these (new) tape-drivers.

HTHKarpi

This discussion is closed to new replies.