Discussion Locked

Testing Technique: Discuss Problem of this

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Do you know about Testing technique that applies in PCBA factory.
I'm know there are many technique but not clearly.Could somebody share something about this.

6 replies

by tig2

I don't think you are talking about "Physically challenged bow-hunters".

What are you looking for? Please define PCBA so that we can speak to your specific question.

Thank you.

by mjd420nova

I'm very familiar with Printed Circuit Board Assembly testing if that's what you meant. I can define more if that's what you meant.

by vanthaikhang

PCBA stands for Printed Circuit Board Assembly. Could you share more information of those techniques? How to maintenance these systems and spring probe. What is your job? Do you like it.

Thanks for your information you sharing.

by mjd420nova

I'm sorry I didn't get back to you sooner. PCBA is usually part of a system used by the manufacturers to do quality control on what they make. Most consist of "bed of nails" test jigs that require the placement of the board into a test fixture that has a large number of contacts that match with certain points on the board to either monitor signals generated by the board or to input test signals into the board or both. Other systems use board edge connectors and clip on "chip clips" to either monitor or input signals. Other approaches are a combination of both and also have built in systems to input fault signals to check the validity of the test fixture itself and insure the propagation of those injected faults to other monitoring points and detect those failures. This is usually done after prototype interfaces are built and to develop test programs that will probe the board and insure that any and all tpyes of faults will be found.

This discussion is closed to new replies.