Discussion Locked

third party performance monitor

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an NT server with 85 PCs, 100 users, and 15 printers. Its the only server, so it is the domain controller, print server, file server, etc. I want to run HelpDesk software managed from a server and also an InOut Board. Administration wants to add Exchange server and also run multimedia training software for our staff.

Of course, all this stuff can't run on one server. But I'm being pressed to prove that with benchmarks or performance logs that say the server has a full workload managing users, security, file access, and printers. The problem I have with the Performance Monitors in NT/2k is they don't seem to match what my instincts tell me. Does anyone know of any third party software that can help me out? I can't allow my domaincontroller to be loaded down with any more tasks.

4 replies

by paulo.sedrez

You can use MIB extensions to Performance Monitor and MRTG (http://www.mrtg.com) to graph the utilization of your server. Check the MRTG Companion Sites and other resources at the MRTG home page.

Using SNMP, you can generate the graphics from a client PC, so this will not load your overloaded server.

A graph showing > 80% of CPU utilization on work hours should be enough.

--Sedrez

by venven

Thanks, I'm not sure about the MRTG, but I'm gonna try a few different monitors. It may be a while before I can get to it and I don't want to leave this open, so thanks for the advice.

This discussion is closed to new replies.