Discussion Locked

Transfer XP Professional HDD to new Comp

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My motherboard recently died. I was running Windows XP Professional with SP1a. What is the least stressfull way to transfer the hard disk to a new temporary computer? I would need to transfer the hard disk again to yet another computer after two weeks.

5 replies

by wcp

1). Back up the hard drive by ghosting it or copying the data before each transfer. This is a no-brainer.

2). Be ready to reinstall Windows. Replacing a motherboard (MB) TYPICALLY generates a Blue Screen of Death (BSOD) unless it has the same kind of chipsets as the old one. If this happens, you need to install Windows on top of the current one. Your programs and data should be intact after the reinstallation. But you have to do Windows update all over.

3). Be ready to reactivate after each transfer. After the Windows got working (no more BSOD before login) you will be required to reactivate immediately. You may have to explain Microsoft what happened.

by timwalsh

Much greatly depends on the differences between the motherboard on which Windows was installed and the new motherboard(s).

You will experience the least stress if you purchase/use a motherboard that has the same chipset/IDE controller

If the new motherboard uses a different chipset, you are very likely to end up with a INACCESSIBLE_BOOT_DEVICE error during boot-up.

If the original motherboard is no longer available/working, you can usually fix this by running a repair install of your OS. This allows Windows to detect the new IDE controller and install the proper drivers. But there is NO guarantee this will work. It doen't work 100% of the time. There is also the additional downside that you need to go back and reinstall all Service Packs and updates. But it's better than having to wipe the drive and start all over from scratch.

If you plan on switching the HDD between two working computers that use different chipsets, there are some steps you can take BEFORE you move the drive. Follow the steps in MS Knowledge Base article 314802. This installs generic drivers for ALL the most common IDE controllers. Although MS claims this is an unsupported procedure, I don't recall it NOT working when I have used it.

Good luck.

This discussion is closed to new replies.