Question Locked

Transfering files from laptop to desktop. Ethernet cable, no router.

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have alot of files I need to transfer from the laptop to the desktop.

All I have is an Ethernet cable, no router. I was trying to set up a a p2p (or PnP) connection between the 2 machines earlier to transfer files between them.

Basically what I did was go to the network connection Properties->TCP/IP changed the IP's to 10.0.0.1 and 10.0.0.2 as well as the one below the IP to 250.250.250.0 on both.

I was able to open a command prompt and ping the other machine from both sides but was still unable to transfer files.

What am I doing wrong?

8 replies

by oh smeg

If so you need a Crossover Cable as the LAN Cards are unable to talk to each other without a Hub/Switch or Cross Over Cable.

Depending on the OS being used you also need to share folders so that they can be seen from the other computer.

If you are using some form of Windows running the [b]Network Setup Wizard[/b] will probably be of some help as well.

Col

by cmiller5400

10.0.0.1 on the first one and 10.0.0.2 on the second. Set the subnet mask to 255.255.255.0 on both of them. Make sure that the Ethernet cable is a crossover one or most likely they will not talk to each other.

by thumbsup2

Be sure you have a cross-over ethernet cable, not just a patch cable. Then, you need to set up file sharing on the laptop so the desktop can "see" it.

by dhuffine

Give up and spend 10 bucks on a 1 gig USB drive :)

Hey arnt you the one that screwed up his mother's computer because you wanted to move some pirated software? Did she ever get her laptop fixed?

by cbader

Get a crossover cable and if you are using XP use the file and settings transfer wizard.

If all else fails get a thumb drive or a cheap hub.

by smash_devour

Is the one from my cable modem.

I just disconnected it from the modem and into my laptop.

I take it this isnt going to work?

by oh smeg

This is a Patch Cable and not suitable. You need a Cross Over Cable to directly connect. If you insist on continuing to use this cable you need either a Joiner and a Short Crossover Cable or a Hub and another Patch Lead.

The Cards that you are plugging into are not designed to accept a direct connection without a Crossover Cable or a Crossover Connection between the 2 computers.

Col

This discussion is closed to new replies.