Discussion Locked

Tunnel not establishing b/w PIX &Nortel

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi ,
i have created a VPN site to site to tunnel to another site .One end has PIX and the other end terminates with Nortel box .
The tunnel is properly established and it works fine almost all the times .I can see the whether the tunnel is esatblished in the PIX firewall and it shows the tunnel is created between the remote and local end.
But at some times i see that the tunnel is not established and it shows in the pending state when i check with command line in the PIX.
When i shutdown and restart that it works again fine and after some time the tunnel is established.
This is not the problem on the other end (nortel box) since i can access the same from my VPN dialup account ....

What could be the problem ,why it builds again when i restart whereas through the same firewall i'm able to browser other sites ...
is it a internet line problem or any hacker attempt.

please help

1 reply

by Former member

If you are using older PIX code, try upgrading to the latest version, example: If you'r eusing 5.x, udate to like 6.3 or whatever the new version is. Appearantly there have been many reports of Cisco PIX not re-establishing the tunnel automatically, especially when connecting to a non-cisco end point. Or you can try the following commands to re-establish manually:

clear crypto ipsec sa and clear crypto isakmp sa

If you continue to have problems, contact the Cisco TAC.

This discussion is closed to new replies.