10 replies
by cartes
Well, I got two NICs on my server too and it works fine. On top of that, both the NICs are exactly the same. But, I did hear about some IRQ sharing problem with NICs in MS Site. Could you give a little more info on your hardware?
1810hrs on 15/Nov/2002
by elemzy
by quintar51
by elemzy
Something you should check would be your route tables. When you install your network cards and assign IP addressed, the computer automatically sets up a routing table. Howerver, it may be comfused as to which NIC to use for which network.
For this answer, I will use two networks of 192.168.1.x (network A) and 10.10.10.x (Network B).
From a command prompt, type 'route print'. This will give you a current routing table. I will also assume a NIC IP address for Net A of 192.168.1.1 and for Net B 10.10.10.1. On top of this, I assume your network is a Class C, with mask of 255.255.255.0. You will need to edit this so that the following information is included.....
Network Dest. Netmask Gateway Inter
192.168.1.0 255.255.255.0 192.168.1.1 192.168.1.1
10.10.10.0 255.255.255.0 10.10.10.1 10.10.10.1
You will need to delete any routes that do not meet these settings. What all of this is doing, is telling the server, where to find an interface for a specific network. Please note, there will be lots of other routes in your table. The only ones you should be interested in are where your network destinations are 192.168.1.0 and 10.10.10.0
Hope this helps.
by elemzy
by elemzy
by elemzy
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending