Discussion Locked

Ultra ATA UDMA

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I took the Ultra ATA cables off my Maxtor IDE hdds
to use them to build a comp for a friend, ever since I have tried to reinstall them on the very computer they came off of they cause the BIOS to not recognize the drives and thus hangup...I have tried everything I can think of from going back to the MS drivers to VIA BusMaster IDE drivers and VIA BusMaster Filter drivers all to only pull my hair out...any help be most appreciated, signed "Goin' Bald"

2 replies

by saihib

Are you sure nothing has happened to those cables. They have 80 wires running through them and it doesn't take much to damage them.

by pctech

Should you have the drives set as Master/Slave, insure that you the end of the cable is on the Master drive. This usually does not cause a problem on the newer systems, but I have seen it do so. You may also want to check to see that pin 1, the colored edge of the cable, is on pin 1 on the hard drives and on the motherboard. Also check to see that the cable is fully seated on the drives and the motherboard.

I hope this helps.

This discussion is closed to new replies.