Question Locked

Unable to access network via 2950 switch

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Previously I was able to access my employment network via 2950 switch without having to configure the switch, now I have no access via the switch but I able to access the network via
10base hub. What do you think could have went wrong and how can this be corrected.

6 replies

by netman1958

Could you tell us more about your problem? You say this is your employment network you're trying to access. Where is the 2950 switch located when you are using it and where is the hub when you try to use it?

Without knowing more details, just off the cuff, if you are unplugging your computer from the wall jack and then uplinking the 2950 to the wall jack, the 2950 is most likely running STP and your network admins have BPDU Guard or Root Guard enabled on the switch connected to your wall jack and it is causing your port to go into errdisabled state.

by jds_sherman

The setup is - From the patch panel rj45 is connect to a Linksys SD2008, a RJ45 was connect directly to my PC.I needed to network printers, servers etc. Connected Cisco 2950 switch, everything work fine. Last week I was unable to touch our network server via the switch. I connected the 10base hub to the 2950 switch which enable to logon to the network server.

by netman1958

Could you show a diagram of what sequence of connections works and which sequence doesn't work kind of like this:

Works:
PC->10bt hub->2950->linksys->patch panel

Doesn't work:
PC->2950->linksys->patch panel

Edited to add: If the sequences I show above are correct, then are you connecting the 10bt hub to the same port on the 2950 that you are connecting your computer to?

by jds_sherman

Works:
patch panel->linksys->10bthub->PC

Doesn't Works:
patch panel->linksys->2950->PC

by netman1958

Well, lets start with the simple, on the 2950, does the light over the port that is connected to the linksys come on and turn green? If it does then does the light on the port that you connect to the PC come on and turn green?

Are you able to establish a CLI to the 2950 via telnet or the console port?

This discussion is closed to new replies.