Discussion Locked

Unable to change resources on Win '95

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I can't change the IRQ or memory address on
my Win '95 computer... ERROR: "Can't change
resources.." Why? I can change on other computers but on some of them I can't!

Pls. help!

7 replies

by mmccaskill69

Q131242 The article really does not give a good explaination.

If you are having resources conflicting you could try the following.

In device manager open system devices.
Locate PCI Bus and open to its properties.
Under IRQ steering uncheck the box to use IRQ steering.

Restart the system.
This will reassign the resources.

by formula

You can only change resource settings on devices that support it (or in some case, drivers). Some devices support only one setting and cannot be changed, thus when you try to manually change the configuration, Windows won't let you. Some devices will support multiple settings, however, if you have the wrong drivers installed, changes cannot be made. Try downloading the latest drivers. You weren't specific as to what you are trying to change, but remember, if drivers are set up correctly, Windows CAN share multiple IRQs.

by bpalmer

One other thought in addition to the ones above... Your hardware may use jumpers to set IRQ's, sound cards, add in ports,, and some nic's do this. If this is the case you won't be able to change through windows you have to remove the device and change the jumper setting(s) on it to change irq. I had one serial board that used a combo of jumpers and special software from the manufacturer. If you didn't match the jumper settings with the manufacturers software settings Windows would just tellyou the device wasn't working, but when they both matched windows would display the settings properly but wouldn't allow changes.

This discussion is closed to new replies.