Discussion Locked

unstable system after installing memory

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My windows 98 becomes unstable and won't hardly even boot up after I upgraded memory and installed two modules of 256 DDR ram. It works with either module just fine but not both. The manufacturer of the computer said it should handle 1 G of memory. Any ideas how I can get both modules to work together?

3 replies

by thechas

There is a bug in the Windows 9X code that can cause instability and other problems with Windows 95 - Me with over 511MB of RAM installed.

The BUG is VERY configuration dependent.
Microsoft's suggested solution is to reduce RAM to less than 512MB, either physically, or by adding a maxmem statement to the startup files to set the amount of RAM that Windows uses to 511MB or less.

Here are links to 2 Microsoft Knowledge Base articles on the subject:

http://tinyurl.com/63mt

http://tinyurl.com/4kiy

The only real 'fix' is to switch to either Windows 2000 or XP.

Some benchmark tests show that W98 has 'optimum' performance with 196MB of RAM.

I limit my 9X boxes to 384MB to avoid the problem.

Chas

by fred07

TheChas is right unless you can use RAM in Bios to dump at least 32mgs. I am suprised he did not add that 98 benches best at 196megs.

by wlbowers

To take full advantage of that much ram and to get around the 512 limit. Upgrade to win2000.
Good Luck Lee

This discussion is closed to new replies.