Discussion Locked

upgrade problem to 98se+usb card

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have upgraded to 98se and added usb card.
some of the drivers for my sound card could not be installed because 98se could not find any spare irq.the tswizard is giving me the option to disable a device 1. my card modem.
2.3dfx voodoo 3.
3.lucent usb open host controller.
4.ali pci to usb open host controller.

whilst 98se was detecting new hardware it detected a second modem when i only have one
mf 3850(eur)faxmodem(aztec)
my sound card is an Aztech sound card MMPro 16III S
can anyone give me any advice many thanks
Dean.

5 replies

by mckaytech

It sounds like you have a couple of driver issues going on, and not just with the PCI bridge. But think answer #1 is correct that the first place to start is with any motherboard drivers.

Then I think I would delete both modem drivers, reboot and have it auto-detect all over again.

If you have some older hardware, and it sounds like your sound card is in that category, you might have to manually configure one or more of the cards because they don't fully support PlugNPlay.

What I usually do in that case is remove all the non-critical cards and drivers, re-boot. Then add each one back in order of importance, let them auto-detect and then manually configure the last card if necessary to solve an IRQ conflict.

paul

This discussion is closed to new replies.