Discussion Locked

Upgrade Win 3.1 toWin 95

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Could someone please refresh my memory on upgrading my Win 3.1 to Win 95 on a small 500 meg PC hard drive?

7 replies

by sreejumon

Please give the details of the system such as RAM,peripherals.
waiting for an early reply

by tbradley

First, I assume you are using the upgrade disk, vice doing a full new install of 95.
If you don't have the upgrade disk, you will have to wipe out all programs/data on your drive, so be prepared to do a full backup in
either case.

delete any unwanted programs, as you are going to need about 150mb of disk space to do the upgrade. Run an aggressive scandisk, so any bad sectors get marked, and do a full defrag.

Be prepared to spend some idle time if you have less than 32mb of ram. Win95will run with 8mb or 16mb, but it is sllooooowwww.

Have all your drivers ready, as win95A ver doesn't have the full range of drivers that the B or c versions do.

I would also have Svc PK2 and the TCP/IP update downloaded and ready to apply, as ver A is very buggy.

Good Luck

by dkpalmer

It's probably not going to be too much of a problem since the original Win95 had pretty much all the drivers and support you would need for an old 3.1 system - but having the manufacturer's drivers handy is a good idea.

Also, if you want to startclean, you can format your hard drive and still install the upgrade - just put Disk 1 of the Win3.1 diskette set into A Drive and point to it when Win95 Upgrade asks where your upgrade authentication file is located.

This discussion is closed to new replies.