Question Locked

Upgraded Switches now slow connections

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I swapped out an hp procurve 2524 switch for two procurve 1800's - took the old 2524 and popped it in place of an older switch else where in the building. Our DHCP addresses are generated from a sonicwall TZ170 (connected to one of the new 1800's). Our clients are Win XP SP2 and have been experiencing very slow (up to 10 minutes) to acquire an IP address. Event log shows multiple DHCP entries. Even a direct connect to the same switch takes a long time to login.

Thanks for any guidance you can provide.
Glo

2 replies

by dumphrey

where the packets go round and round untill they get there. But I may be wrong... double check that you have only one connection from backbone switch to each distribution switch, it that fixes it, it was a loop.
My bet is that the problem lies in the 2524 you put in place of an old switch. Put the old one back in and see if that fixes your issue. What type of switch did you replace with the 2524?

This discussion is closed to new replies.