Discussion Locked

USB Mass Storage Device not working

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running XP Professional on my pc and so is everyone in my office. I have several USB devices connected to my pc and they are working fine. Whenever I plug the mass storage device in, Windows gives me a message that it recognizes it, but when Igo to My Computer it does not show up as a drive. I have taken it to several other pc's in the office and they recognize it immediately and it shows up properly in My Computer. I have gone to the device manager and it says the device is working properly. I would appreciate any suggestions you might have.

5 replies

by thechas

Have you tried a powered USB hub?

Many motherboards only provide enough 5 volt power on the USB port to power a few devices.

A powered USB hub usually corrects this problem.

The only other thought I have, is that you may be missing a coupleof XP updates that your co-workers have.

Chas

by jayeliz

I've found that if you use several storage devices; ZIP drive, memory cards, flash cards, etc., XP will give these devices the same default drive letter or will use one of the mapped drive letters. Try changing the drive letters for these devices using the disk management utility.

This discussion is closed to new replies.