Discussion Locked

W2k upgrade W2k3-After 1st boot no NTLDR

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i was upgraing from w2k domain with one server to w2k3. everything went well until i had to restart my computer. i get a error message saying: NTLDR can not be loaded.

2 replies

by omie

Checked your boot up configuration. If you are using SCSI reconfigure and make sure that it is booting in the right drive.

by techrevelation

Are you doing a clean build to W2k3 or doing an upgrade?

Typically, it is best practice to work with a clean install as it leads to fewer problems in the long run. From the sounds of the above, it is possible that it is either an issue with the way the OS configured your boot partition or the controller settings (depending on the type of hard drives you are using). Would help to have additional information on the type of hardware you are using for your drives as various types of drives/controllers have different means of fixing issues like this.

This discussion is closed to new replies.