Discussion Locked

WAN Solution

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a very interesting situation.
I have two sattellite connection point to point between USA and India. Both of these are orignating at one point and termintation at other. Actually each other is back of other and for load balancing if both are up and running. One end of network is 192.192.1.0 network and other side is 192.192.2.0 network. My question how to implement this, what routers I should used, how to dynamically route packets, and how can I acheive load balancing.

thanks in advance.

7 replies

by jfv62

The CISCO 2600, 3600 family of routers will give you the most options and flaxibility with your WAN plan. Are you routing IP traffic only or are other Protocols needed to be routed? Multiple protocols will complicate your routing table(s) on the router.
For simplicity lets say it's only IP. Why not make one router the Gateway from india to US - say 192.192.1.254, any outgoing IP traffic the primary route is via this pipe and the secondary route is 192.192.2.253, your second WICK card on the router.
On the other end (USA) do the reverse and that will give you a pipe mostly incoming and one mostly outgoing. The secondary routes will kick in when there is Naks on the primary routeor it goes down. simple but will work. multiple protocols andother routing needs will effect this, hence the volume of posibilities with CISCO routers and switches.

by techadmin

Cisco.
Depending of your WAN links, you can choose one in the middle of docens of different models.
Perhaps 2500 family are cheaper.
Good options are 2600 and 3600 to

Good luck

by techadmin

Cisco.
Depending of your WAN links, you can choose one in the middle of docens of different models.
Perhaps 2500 family are cheaper.
Good options are 2600 and 3600 to

Good luck

This discussion is closed to new replies.