9 replies
by didierjohn Accepted solution
by oh smeg Accepted solution
But at a guess your new DVD Drive is a SATA Drive and you have previously had a IDE Drive and no installed SATA Drives.
If that is the case you need to add the SATA Driver as XP doesn't natively support SATA Devices.
If this is the only Optical Drive you have you can always download the SATA Driver from the Samsung Web Site or if you are using a SATA Controller Card you'll need it's driver which you can get from it's maker.
Col
by didierjohn Accepted solution
by sathis2study Accepted solution
my guess chk in bios weather it is detecting otherwise enable sata in bios and chk ur sata cable weather it is properly connected or not..
enjoyy
by didierjohn Accepted solution
by oh smeg Accepted solution
It is the Jumper incorrectly placed here that is the problem.
It needs to be set the same way as the one that came out of the unit to either Master, Slave or Cable Select CS.
This jumper is a row of 3 Pins 2 wide between the IDE Lead and the Audio Out Connector.
Col
by didierjohn Accepted solution
by oh smeg Accepted solution
Well then you are going to have to load the drivers some other way.
I would suggest going to Samsung Web Site and downloading the drivers, unzipping as required and then Open the Device Manager and right Clicking on the Device and choosing Update Driver from the selection.
When you are prompted for the location of the driver point it to where you saved the driver and let it install. ;)
Col
by rahbm Accepted solution
This discussion is closed to new replies.
Trending Storage posts
Sort by Trending