Discussion Locked

win 98 install

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I try to install Windows 98 from Dos on an old Pentium MMX machine with 128 MB of RAM i get a meesage that setup needs a certain amount of memory to run. I know that there is more than enough. How do I proceed

10 replies

by highlander718

First, is (all) the memory recognized at boot-up ? If yes, it can't be the memory, maybe the disk space is not enough ? I'm assuming we are talking about an original/official instalation disk here ...

by thechas

Are you installing W98 from DOS, or from a W98 startup disk.

You need the high memory manager from the W98 startup disk in order to get W98 to install.

DOS on it's own, only recognizes 640K of RAM.

If you do not have a W98 startup disk, or access to a running PC with W98 on it, you can download startup disk images from the links at www.bootdisk.com

A DOS boot disk is NOT the same as a startup disk.

Chas

by blackcurrant

Hi

You can free a little more memory by removing the CD drive driver from the startup files config.sys and autoexec.bat, plus any other utility programs that may be loading from there-

Boot into DOS, insert your Win98 CD in the drive, and fromthe command prompt type:

MD WIN98
CD\WIN98 (no spaces)
Copy :\win98\*.*

This copy the installation files from your CD to a folder named WIN98 on your hard drive.

Next type:

CD\
EDIT AUTOEXEC.BAT

This will starta text editor and load your autoexec.bat file. Identify any lines from which programs are running and the CD driver (this line can be identified because it has MSCDEX.exe in it). Type REM at the start of each of these lines. The REM statement tells the operating system that these lines are REMarks, and that they should not be processed. When you have finished press the ALT key, then F, then X (ALT,F,X) to exit the editor.

Follow the same procedure for CONFIG.SYS.

Doing this will make windows load only those lines that are required, freeing more memory for use with the installation program.

Reboot and type MEM at the command prompt. The MEM command will tell you how much memory is available. Is it the same as or exceeds the amount of memory that Windows needs. If it is lower, edit the files again and REM the keyboard and country lines. Do not worry about a memory manager. Windows installation program often loads this when it starts.

This should free up more memory.

Good Luck

by blackcurrant

The most important bit, which I forgot to mention, was that after you reboot using the edited Autoexec.bat and config.sys files, type

CD\WIN98

Then type

setup

This discussion is closed to new replies.