Discussion Locked

Wind 2000 Serv. Inaccessible_boot_device

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have a computer with windows 2000 server loaded. I upgraded the server to service pack 4.
When I went to restart the computer I get the following error on the blue screen :
Inaccessible_boot_device
I did not archive the previous servicepack(if that matters). I tried running chkdsk, which did not help.I tried safe mode,last known good configuration. I do have many files I need on this drive.Is this drive recoverable?
Any help as to way and how this may have happened would be appreicated. Thank You

7 replies

by jschein

You said you had this on a computer? I'm guessing just a normal pc? No raid / scsi drives?

If that is the case, you can just slave that drive off with an exisiting 2k machine and copy the files to that drive... Then wipe out that drive and install 2k server from scratch. Recommend after you have that 2k server setup again with all drivers, updates, misc prog's (Adobe, winzip, office, etc.), that you go ahead and make an Image of it with PQDI or Ghost. Just so you always have a full working backup of that system in case something drastic happens down the road.

Good luck.

by kinetechs

Another thing to try;

If the hard drive controller is an ATA66 or greater, try moving it to a standard IDE controller. If your motherboard doesn't have any then swap the 80 wire ATA hard drive cable with a standard 40 pin and see if it'll boot. If this works then try updating the drivers for your ATA controller and going back to the original cable/controller.

Cheers!
~Sean

by sgt_shultz

sounds like the hard disk controller driver got hosed or 'upgraded' see if you can boot with ntfs boot disk and replace driver file with older pre-service pack version?

This discussion is closed to new replies.