Discussion Locked

Windows 2000 Dialin Access

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello Everyone,

I have my PC setup to answer calls for dialin access (I am running Windows 2000 Pro)

My problem is when users connect they have no idea what to do. It says somehow I can give them access to my network Resources, which I need.

Here is my setup:
I have a Router which is acting as a DHCP Server. The Address is 192.168.1.1 which I use to access the information within it (I am guessing that is my DHCP Address?!?!?). All my Local PC's on my LAN have IP addresses specified by my router.

The Router obtains the Internet information from my Cable Modem (under WAN).

Now I have the following protocols setup for dialin:

TCP/IP
IPX/SPX/NetBIOS
File and Print Shairing
Client for MS Networks
NWLing NetBIOS

TCP Properties are:
Allow callers to access my local area network
Assign TCP/IP Addresses automatically using DHCP

IPX/SPX/NetBIOS Properties:
Allow callers to access my local area network
Assign same network number to all computersAssign network number automatically

Client for Microsoft Network Properties:
Windows Locator

I am not sure if those settings would allow the client to connect to my LAN. I checked everything and it all checks out, but how do they access computers and files on my network? and would they be able to access my internet access also?

The Remote PC has the same setup as mine (its one of the computers on my network, a labtop used for testingm which I disconnected from my network to see ifI can get it access through dialup)except it is setup to call, not recieve.

Any help?

5 replies

by blaine moore

Are you setting up a new dial-up connection on your client? Try using the wizard and dialing in from outside your network. I never had much luck when trying to dial in from on-site, but I don't have much to support for dial-up so I haven't worked a lot with it.

by michael34

Yeah, me either. I have little dial in access. I think we are going to dump this project and just upgrade to High Speed.

by curlergirl

Do you have the Routing and Remote Access Server configured on the Win2K server? How are you connecting and how is RRAS configured - for VPN or dial-up through a modem? RRAS has to be configured properly to allow connection and assignment of IP addresses through one or the other (or both, if you are using both). In your case, since you are not using Win2K as your DHCP server, I would set it to manually assign IP addresses. You don't need IPX/SPX or NWLink for remote access, only TCP/IP. There are a few intricacies to setting up RRAS if you haven't done it before - look it up on the Microsoft support website. Hope this helps!

by michael34

We configured both of those and still no luck. Dialin access, no one can get access to the files we need them to.

This discussion is closed to new replies.