16 replies
by thechas
I believe that the easiest way to take care of this problem is going to be to re-install Windows 98 on top of itself.
You need a startup floppy disk
and your W98 CD.
DO NOT USE A RESTORE DISK!!!
Use only a true W98 CD.
Set your boot sequence as needed in BIOS settings to boot from the floppy.
Answer yes to install CD-ROM support.
At the DOS prompt, run setup
Follow the prompts for a custom setup, and be sure to have setup use the same folder as your existing installation.
(C:\Windows)
You may loose some settings, and need to re-install a few Windows updates, but you should not loose any files.
As soon as the system is running, back up those precious critical files.
Chas
by kenny5763
by an_it_guy
You can try removing this hard-disk and plugging it as secondary into any other PC that you can, and access all your data and back-it-up. Then you can go ahead and reinstall the OS, since you never know what all gets wiped-off while reinstalling.
Best of luck.
by kenny5763
by aquaraydee
by kenny5763
by dirkdj
by kenny5763
by chriswales
Boot from a Win98 diskette and run chkdsk/scandisk.
Resolve any errors there.
Can you Boot into SafeMode? *uhh. I'm an idiot and can't read. Sorry, see that you can only go to safe mode command*
If you can it's probably just some file corruption and you may be able to just replace those 3 files.
I would also try a Virus boot disk as well and scan the MBR, etc for virii.
After that, you may have to use "sys C:" to put some of the new system files on your root drive.
by ex_s_ky
1..reboot your pc..and thenn press F8...and choose command promt only. after that u just type 'SCANREG'.windows will automatically make a backing up your data.
2..if that there is no respon to your pc..just put your windows start-up disk and then... a > rename your command.sys to another name...and then copy your new command.sys to c:\ b > do the samething to himem.sys and make sure u rename it's first.
after that do the first step (1) ....just reboot and press F8 and choose Command Promt Only...and type scanreg...
if there is no respon..i think u should make backup your file and format your hard disk..
by kenny5763
by hillwr
Did this just happen? Try rebooting your pc,
then press F8, and choose command promt only.
At the command prompt, type scanreg /restore
This will bring up the last few good registry's.
Pick one frtom an earlier date and then reboot
when prompted. I've had to do this sevedral times
with success. Good luck.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending