16 replies
by hberkhoff
Make sure the computeraccounts (of winxp pro workstations) exists on the new win2k server.
If not, create them. Otherwise get WinXp workstations to act in Workgroup, and after reboot connect them to the domain again.
by rmckelvey
by sgt_shultz
can you ping the server? if not, check tcpip settings (ip address, gateway)
you sure it is not connectivity issue? have you moved the computer to a known good network jack? tried logging in with domain admin password? tried another nic?
by rmckelvey
Check cabling and switch port - this message usually comes up when there is a communication problem.
I would think that when disconnected from the network no domains are available, since the PC is included in the domain list. You can still logon tothe PC as administrator, but only a 'dial up connection to your domain will be available.
by rmckelvey
by hunter
Try using the ping command to make sure you have connectivity. If so try the following:
This problem is more than likely a DNS issue. If your primary DNS server is not a dynamic setup then the XP machines are unable to register themselves in the directory. Since Active Directory uses DNS rather than netbios to resolve names you need to be sure it is set up correctly. If your Win2k server is not your primary DNS server you will need to add the DNS service to it and make it the primary DNS forall of the client machines. Then, add accounts for each of the machines or make it Dynamic and allow them to do it on thier own (I prefer Dynamic)
by rmckelvey
by rmckelvey
Thanks for the responses, I managed to unjoin the domain but now that XP pro station wont rejoin saying the following.......
"Multiple connections to a server or shared resource by the same user using more than one user name are not allowed "
I cant find this error anywhere on Microsoft site
by ctmoore1998
Is your 2000 server's DNS configured?? If you are running DNS install the support tools and run NETDIAG to insure that it is properly configured. Next are you STATIC IP or DYNAMIC? IF DHCP then make sure it is providing the proper information for IPand DNS (2000 server should be PRI DNS SVR)
If STATIC go into the NIC properties and check the IP configuration. Ensure that the IP, subnet and gateway information are correct and that the primary DNS server is set to the 2000 server you should then be able to join the domain and add the domain user to the workstation
by rmckelvey
by maholtz
by rmckelvey
by o.holmgren
by rmckelvey
by rmckelvey
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending