11 replies
by quintar51
by marlou_mac98
by alveden
Did you set up the ADS in native mode or mixed mode? If all your win9x, including NT4 workstation have problem logging on to Win2k, most likely you have configure the ADS in native mode.
native mode does not provide backwards compatibility for support win9x and NT4.
For backwards compatibility you need mixed mode.
Just a thought ..
by marlou_mac98
by simon.weaver
What settings have you made on the Win98 client?
You dont need to add anything in ADUC - simply ensure the Win98 has the correct IP Address, WINS entries and Domain Name.
Reboot. Can you ping the server by IP or Name?
What error message do you get?
Check the settings and try again!
Simon Weaver
Tech Consultant
www.iscl.net
by marlou_mac98
by shortbus
by marlou_mac98
by j.black
If your w2k server is running DHCP, ensure the following:
1) Make sure that the w98 client uses the same domain as the w2k pdc.
2) on the w98 client, under tcp/ip/advanced enter the gateway ip addr for the w2k server.
3) after restarting the client and the client is still not able to log onto the server, run winipcfg to check the ip addressing of the client. if the client is not on the same ip network then try to release/renew the ip address.
4) if the above does not work then you may have to remove all network settings on the client, reboot the client system to re-initialize/redetect the network settings on the client.
by marlou_mac98
by marlou_mac98
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending