Discussion Locked

WINNT INSTALATION ALONG WITH WIN-98

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I HAD A HARD DISK OF 20 GB AND WANT TO INSTALL WIN-98 AND WINNT 4.0 SERVER ON THE SAME MACHINE, USING WHOLE DISK SPACE AND MAKING PARTITIONS OF 2.1 GB EACH.I AM ABLE TO INSTALL WIN-98 ,BUT AFTER THAT WHEN I INSTALL WIN-NT SERVER IT CRASHES. THEN I REMOVE ALL THE PARTITIONS AND LEAVING ONLY
ONE PRIMARY PARTITION OF 2.1 GB, AND WINNT WAS INSTALLED SUCCESSFULLY(SP3) AND CREATED NTFS 3 PARTITIONS OF AROUNG 5 GB EACH . BUT AFTER THAT WHEN I TRIED TO INSTALL OPTION PACK 4.0 IT GIVES ERROR COULD NOTDETECT OS TYPE. HOW CAN I MAKE THEM WORKABLE. BY MAKING ONLY FAT16 PARTITIONS OF 2.1 GB EACH.
TELL ALL THE STEPS ASSUMING THAT 20 GB HARD
DISK IS BLANK. IMPORTANT ALL THE SOFTWARE IN
WIN-98 OR IN WIN-NT SHOULD WORK PROPERLY

9 replies

by bill cassada

I posted the answer to this under the first instance of the question...look there. Let me know if I can be of any additional assistance.

by flan

you can have only a max of 4 partitions on one hard drive on winnt. if you want a dual boot machine, it is best to install them onto different drives because you don't want two os's to use the same program files

by bdivine

Create two partitions. make one a 4 gig vfat and the other a 10 gig fat 32. Install windows 98 first. Install windows NT second from within windows 98 to 4 gig vfat partition. When the machine reboots you will have 3 options winnt 4.0, 4.0 vga and windows 98. Winnt will not be able to read or see the fat32 98 partition. After you install your server then use the remaining 6 gig to create an NTFS partition for NT. Email me if you have further questions.

by jyimcse

First create one partition using fdisk without large disk support. This will allow you to create a FAT16 partition with a max of 2GB. Then load Windows 98. Then use the Setup disks to install NT. during the setup it will ask you where you want to setup NT on C: or unpartitioned space. Select unpartitioned space and then it will ask you if you want to format the space with FAT16 or NTFS. I suggest NTFS so you can make a 18GB partition, but you can format with FAT16 making a 4GB partition. Load the rest of the NT Server. If you use FAT16, then you can use disk administrator to add additional FAT16 or NTFS partitions

This discussion is closed to new replies.