I just had this problem with x86 Solaris on a server I built with different model card. Scan shows the card and driver, but bootup doesn't load it. I had to manually add the device files and links. boot -r (or the fresh install) should and normally does do this but in this one case it didn't. Before we get into those procedures lets first make sure your setup files for the interface are correct.
There should be an /etc/hostname.interface file (if your interface is iprb0 it is hostname.iprb0) that has one line listing the server's name.
Then /etc/hosts should have the same name assigned to the correct IP address.
Then /etc/netmasks should have the correct netmask for the network this IP address falls under.
If you had to correct/add anything here you should be able to reboot now and ifconfig -a should show your interface as up.
If that did not work try ifconfig iprb0 plumb (again assuming the interface is iprb0, but it may be different on your server). If this fails then you should try the following:
drvconfig
devlinks
Once this is done you can initiate the interface with ifconfig iprb0 plumb
Then assing the network information with
ifconfig iprb0 inet your_ip_address netmask your_netmask broadcast your_broadcast up
or you could just reboot.
However, if ifconfig iprb0 plumb worked you have a problem with one of those three files mentioned in the beginning and you need to re-verify that everything there is correct.
I hope this helps.