Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I upgraded to XP and lost my ability to use my slaved HDD. Although any other HDD will slave. The problem must lie in the fact that my primary HDD and hoped for slave are the exact same make and model. Although I realize maybe the motherboard may need to be upgraded. All worked well in ME but not XP.
3 replies
by dmiles
try this site.
http://www.planethd.com/support/drive-install/tour/
by sit0nmyfase
Did you install WinXP in NTFS or FAT32?? if NTFS and your slave isnt set up for you will want to format your master to FAT32
by chrisdent
Did the BIOS pick up the drive on boot?
If so chances are XP just neglected to assign it a drive letter.
Go to Control Panel, Administrative Tools and open Computer Manager. Then Select Disk Management.
You should be able to see all drives attached there. If there is one missing a letter you can add one there under the right click menu (Change Drive Letter and Paths...).
I would point out that there is absolutely no need to reformat your first hard disk as FAT32 and would advise against doing so.
Hope this helps you out.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
0 helpful
15 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply
0 helpful
2 replies
0 helpful
10 replies
Question Unanswered
i need help in transferring my bulk emlx files
0 helpful
0 replies