Discussion Locked

XP INSTALL CODES DON'T WORK

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I AM JUST GETTING INTO NETWORKING PLEASE BE PATIANT IF I SOUND STUPID. I LEARN QUICK. I CRASHED MY COMPUTER I TRYED TO REBOOT MY SYSTEM WITH MY SOFTWARE BUT IT WOULDN'T TAKE MY CODES. I FINALY HAD TO GO BACK TO 98. WHAT CAN I DO TO GET THE CODES TO WORK OR GET NEW CODES?

9 replies

by dmiles

If the setup of XP is the original setup on this computer then you should be able to run setup with the current cd key,the other option that has been discussed when XP was released and their were hardware changes you had to contact Microsoft.

type in the cd key exactly as they are on the case,if this is a copy then you may have to try finding a way to bypass,which may not be helpful to finding

by cactus pete

You may have hardware issues. If the disk is bad, or corrupted, or the processor needs to be reseated, or the RAM is bad or needs to be reseated, then you can experience this sort of behavior.

Clean out the inside of the machine, and blow out the points of contact for the various components. Also be sure to run a thorough scan of the disk before installing XP.

by sonnguyen

Code that come with the xp copy will work if you've lost the code contact microsoft.
Mix-matching code from one version to the other ie xp home, xp professional will not work.

by bristar

Make sure to check for possible typos as well. A 0,O, and D, can look a lot alike. You might have inverted a couple of numbers, You might have mistaken a 7 for a 2, or a 5 for an S. B's and 8's can look alike, so can 6's and G's. Check your E's and 3's and if you a little dyslexic like me, you might even invert a 4 for a P.

Try some variations.

This discussion is closed to new replies.