4 replies
by jon.templeman Accepted solution
by older mycroft Accepted solution
You cannot use a previously installed HDD and fit it to any system other than the system it was installed within. All the chipset drivers on this HDD are only for the system where it was fitted when XP was installed on it.
It won't work inside another machine because none of the drivers will match up with the new chipset.
What you need to do is to wipe the HDD then reinstall from scratch for this new machine.
However, you'll have to ascertain that you can find replacement drivers for all the currently installed drivers, BUT ones that are compatible with this new machine.
You should find all these new driver installers BEFORE you wipe the HDD otherwise you may end up with a HDD that does not work in either machine.
by rob miners Accepted solution
by oh smeg Accepted solution
They have both failed to address the basic Hardware conditions involved in Fitting a IDE Drive to a computer with only a SATA HDD. The Hardware always sees the IDE Drive as the Primary Boot Drive so all of the Basic Boot Files are copied to this HDD. This includes the Boot Loader that allows you to select the Different OS's at boot. If the Vista OS has a IDE Drive added the necessary files will not be on the IDE Drive to allow the system to even see the SATA HDD telling after the Boot Process has started.
Similarly the IDE Drive because it came from a Different computer has the Wrong Drivers and HAL File HAL stands fro Hardware Abstraction Layer and is effectively a list of the Hardware present in the system. As the HAL files will be different on different Hardware they are not interchangeable between different computers unless that have the same internal components installed. Clearly this isn't the case here so it will not work.
What you need to do here to make this work is to repair the HAL File by doing a In Place Install and to do this you need a M$ Branded Install Disc for XP as apposed to a Slipstreamed System Makers Recovery Disc. If you do not have a M$ Branded Install Disc you [b]Can Not[/b] do a In Place Install because the required files are not present on the System Makers Recovery Disc.
Follow M$ Directions here to do a In Place Install
http://support.microsoft.com/kb/315341
You will also meed P Drivers for most of the Hardware of this new computer and you will have to download them from the Internet but unless your current system had the option of coming loaded with XP the System Maker will not have these drivers so you will need to search the Internet for them if they even exist. If you do not install the Drivers the Hardware that they where written for [b]Will Not Work.[/b] The drivers you will need include the M'Board Chip Set Drivers, The Audio Drivers, the Video Drivers, Keyboard/Mouse Drivers. Ideally here you should open the Device Manager in Vista make a complete list of Installed Drivers and download the XP Versions of them before you proceed any further if they exist. If they do not exist that Hardware will not work.
Once you have got XP reinstalled it will not allow you to start up Vista so you need to repair the Vista Install so follow the recommendations from Jacky above about doing a Startup Repair.
However where Jacky is wrong is that the new M'Boards [b]Do Not[/b] have 2 IDE Chanel's they only have one and you need to fit the IDE Drive to a place on the IDE Data Lead where they will physically fit and as generally speaking the Optical Drive is on the end of the lead you need to fit the IDE HDD to the Middle connector on the IDE Lead so you need to set the HD to CS [b]Cable Select.[/b] The other thing here is if you do not have a IDE Optical Drive in this new computer you need a new type IDE Lead as this M'Board will not work with an old 40 Way IDE Lead you need one of the 80 Way IDE Leads that is one with 80 Wires in the Ribbon Cable not 40. If you do not use the correct IDE Data Lead the system will not POST or proceed any further.
Col
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending