Discussion Locked

XP PRO VPN SERVER PROBLEMS

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My set up is this: Two offices, both with DSL. One
XP Professional PC at each office. One XP
machine is a VPN server which works fine for
clients within the LAN so I know the server is set up
OK.

My problem is connecting VPN clientsoutside the
office. We have an Actiontec DSL/Router. It is set
up for IPSec/L2TP passthrough and PPTP is set up
by default. It has the latest firmware. I have port
1723 open and set up to forward to the internal IP
address of the VPN server. The VPN clients are
configured to use PPTP. When the VPN clients
connect, they get to 'authenticating username and
password' and then times out and I get error 721. I
looked that up on MS Technet and couldn't find
and articles applying to this situation. When I
configure the clients to use L2TP i get a "no valid
certificate was found" error (781 i think).

I have tried connecting also from Win2k machines
from outside the office with no difference. Any
suggestions or help?

11 replies

by acattr

For PPTP you need more than just protocol tcp on port 1723. You also need to forward protocol gre with all ports to your vpn server. Basic firewalls only allow forwarding tcp and udp. If you don't see an option on your firewall, then you can't do it.

Link below shows example of ports opened on a Cisco PIX Firewall.
http://tinyurl.com/4lyb

Config Below:
access-list acl-out permit gre host 209.165.201.25 host 209.165.201.5
access-list acl-out permit tcp host 209.165.201.25 host 209.165.201.5 eq 1723
static (inside,outside) 209.165.201.5 10.48.66.106 netmask 255.255.255.255 0 0
access-group acl-out in interface outside

by mason

This may apply to cisco equiptment, but this is just a crappy
Actiontec router. I know it's possible to get it working without any
GRE configuration.

by mike jones

I disagree with the above answer.

I only had to forward port 1723 to my VPN for it to work.

VPN connections are difficult to troubleshoot, but try the following,

Use a invalid password to see if it prompts you to put a correct password in.This sort of shows you that you are getting to the VPN server and the problem is a configuration one.

Make sure that you have disabled any firewalls on the client while you are testing.

Also use the built in function for allocating IP addresses within the VPN server while testing.

I had two problems when I first tried to setup my VPN, I tried to get my Firewall DHCP server to allocate DHCP addresses, which didn't work, I reserved a range of addresses and allowed the VPN server to allocate these addresses and it worked ok.

I have zonealarm on my client and forgot to allow the outgoing traffic.

As you are not using IPSec/L2TP, you don't need to worry about passthru for these services. Just concentrate on PPTP.

Let use know if you get any further.

by acattr

Crappy Actiontec router!

Every router/firewall is different. The cisco was just an example. I would call ActionTec and see if they support passthru of GRE. Apparently answer 2 has one that does it automatically, good for him. But if your devicedoesnt support it, then you need to change it.

This discussion is closed to new replies.