Discussion Locked

Your HDD has switched to the dos mode!

0 helpful
16 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When running win98 a white box, will slow down and start running slow.... I found this out by right clicking my computer foing to properties and checking system resources. A box open on the stating " your had drive has changed to DOS mode.. I added 3 more fans to the system, and the problems still happing. Has any one had this problem & / or found a answer.. Thanks, Bill

16 replies

by Former member

If your disk drives are using MS-Dos compatibility mode then it could be that you have corrupted IDE drivers or it could also be a virus that has infected your master boot record.

by rmmcp

Ok, start by replacing the IDE controller driver files.

Run SFC.exe.

Select "Extract one file...".
For the name enter: MSHCD.INF
Of course the source is the Win98 CD.
Save it to :\Windows\INF

Also, extract the following file to the INF directory:
DISKDRV.INF

Now the spooky part.
Open System Properties\Device Manager.
Expand the Hard Disk Controller tree. Select the parent Bus master controller entry. Usually the first listed (do not select a Primary or Secondary; they are justpart of the parent controller) and Remove it. Scary huh!
Reboot the computer and allow it to reinstall the IDE controllers. This will be using the freshly extracted files. Hope that helps.

by csheltcomp

Reinstall over top of the current if there are no virus' present. This will(85%) of the time get rid of the dos compat. mode.

by s.jong

This problem could also be caused by a DOS atapi driver that is executed by the autoexec.bat. Check your autoexec.bat and config.sys and remove all atapi related lines in those files.

by moflic

You haven't by any chance clicked in system properties something like "disable 32bit file access for disk drives"(or something...) in file system properties? I'm on a linuxbox now, so I don't know how's exactly called, but it's in system properties>file system properties>the last tab i guess... Have you any devices installed in config.sys that drive a hdd/cdrom?

by formula

First, check for a virus, usually Stealth Boot B, NYB, or Stoned Empire Monkey virus will cause this problem (if you have the Monkey virus, email me, I have a fix). Have you checked your CD-ROM? It may be missing. If you don't have an antivirus handy, go to Start, Programs, MS_DOS prompt and type in "chkdsk". Total amount of conventional memory (near the bottom) should read 655,360. If it is any lower, you may have a virus. If you do not have a virus, check your autoexec.bat and your config.sys for any cd-rom drivers. Rem these out. You can also open up regedit and search for "noide", if you find it, delete it. Last, if nothing else works, you need to reinstall the IDE controller. Boot to safe mode, and go to device manager. Delete the PCI IDE controler located in IDE Controlers. Reboot and Windows will reinstall the drivers.

by borgjs

Had a similar problem with a 95 machine. After trying the other steps search your registry for the following key "noide" without the quotes the path should be HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\VxD\IOS I have no idea how this key got there but after removing it 3 months ago it hasn't returned.

by wbkern

The problem turned out to be a bad memory stick once it was repalced the problem went away. Memory checking software didn't find the problem for many trys. I was there when the system switched the drives to DOS Compatable mode and ran memchecker andthe chip showed bad.

This discussion is closed to new replies.