Discussion Locked

0x00000050 in ntoskrnl.exe after SP3

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had a computer that went down due to a:

0x00000071 SESSION5_INITIALIZATION_FAILED

No information worth anything was found so I decided to do a repaired Windows 2000 Installation. This got the machine to work BUT all of the applied updates previous to the crash weren't there anymore. I began installing them. Once I installed SP3, I got the:

0x00000050 PAGE_FAULT_IN_NONPAGED_AREA ntoskrnl.exe

I followed MS instructions to check the drive and nothing was wrong. I then tried Safe Mode. I can boot up into Safe Mode fine and if I uninstall SP3, all works again as well. Has anyone encountered this and gotten it resolved? Thanks, Jeremy

3 replies

by administrator

yes brother but not under your circumstances. In my case RRAS and my DHCP just went crazy, I had to do a reinstallation, repair didn't solve my problems. I installed SP2 and left it at that.

by jeremy the it guy

I have to give this an unacceptable only because there is no answer. It sucks to have a problem when even the makers of the software can only give you what gets printed on the BSOD. I did the same thing. I just installed SP2, did all the updates and just left of SP3. Don't understand but... Thanks, Jeremy

This discussion is closed to new replies.