Discussion Locked

16 meg RAMdrive in W98SE

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How do you set up a RAM drive in Windows 98 SE? I have 80 megs of RAM, and so I tried to set up a 16 meg RAM drive, leaving 64 megs of RAM for normal use. Said there was insufficient memory. I brought it down to 4 megs, same thing. I put /e on the command line, so that it would use extended memory. It seemed to work, but then when I went into Windows, lots of stuff was missing. The only way I could get it to work was to use the default value, which was 64K (not nearly enough space).

Any ideas?

6 replies

by ann777

To create a RAM Drive of 16MB ( 32MB is the maximum possible with RamDrive.sys), include the following lines in Config.sys:

Device=c:\Windows\Himem.sys
Device=c:\Windows\Emm386.exe NoEms
Dos=High,UMB
DeviceHigh=c:\Windows\RamDrive.sys 16383 /E

Enables access to extended memory
Provides access to upper memory blocks (UMBs)
Lets Dos load into high memory and manage the UMBs
Creates a 16 MB RAM Drive in extended memory.

by ann777

The above four lines is all you need in order to create the 16MB RAM Drive... but you might want to setup an autoexec.bat that is empty and a config.sys with only the above four lines, and check if that works. If it works with only the four lines and an empty autoexec.bat, then other devices are eating available RAM and you will need to add devices that you need and see if it still works.

Also note that some of the older devices may not operate in himem. The "mem /c" command also comes in handy to see what contiguous memory you have available; and whether you have enough in upper mem...

by thechas

Depending on your hardware and software configuration, 64MB just may not be enough free RAM for W98 to operate.

To be honest Jim, unless you have some special need for a RAM drive, you are going to end up slowing down your system by dedicating RAM to ANY function.

Adding an additional 128MB of RAM will help your system a lot.

If your goal is to place the page file on a RAM drive, 16MB is nowhere near enough space.

Depending on what you need to accomplish, 1 of the memory managers may be a better option for you.

Chas

by mark

Why the heck do you want a RAM drive? Tell us your problem, not your solution. BTW, Windows 98 should have at least 128MB of RAM to run effectively. I would leave the whole 80 for the OS. What is it you are trying to do?

by jim phelps

All:

Seems like many of you want to know why I want a RAM drive.

I would like to put as much of the "background" stuff as possible into RAM. e.g. my TEMP directory, my print spooler, my temporary internet files.

This provides three benefits: (1) It GREATLY speeds up Windows; (2) all of the useless debris generated by Windows is deleted whenever you reboot; and (3) it saves wear-and-tear on your hard drive.

by jim phelps

Sorry I haven't rated any of your answers yet. To tell you the truth, I haven't had time to implement any of your suggestions. I'll get to it as quickly as I can, and will rate all answers.

Thanks for your suggestions, and thanks for your patience.

Jim

This discussion is closed to new replies.