Discussion Locked

2 NIC same IP ON nt 4.0

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How to configure 2 NIC use same IP for failover on NT Server 4.0

Jacky
Lawanj@telergy.net

9 replies

by ckern

When you are adding the second NIC Card, you have to assign it a seperate IP address. Once you have both cards configured, you choose the primary and secondary card from within the software. At the time of failover, the secondary card assumes the address of the primary card.

by gregory w. smith

Intel has driver software included with its latest NICS for adapter teaming (more throughput & failover) or Adapter Fault tolerance.

Their EtherExpress 100 Megabit and Gigabit cards have it (and will work with their older 100Mb cards as well); you can even have a gigabit connection with 100Mb failover.

Actually, it's really slick. But you will need the appropriate *manufacturer's* driver for the card you have. If your manufacturer doesn't support this, try the Intel cards, they work very well.

by flan

i agree with answer 2. intel has this feature where you can bind one ip adress to two nic cards. it's not really fail over, they just both work at the same time. so if you have 2 100mb cards, you have a total of 200mb. the feature is availabe on the software that comes installed with the nic card (and they can't be intergrated they need to be separate pci cards)

by sfo farmer

I also agree with answer 2: I've used both the Intel's (and Compaq based Intel's). Here's a few suggestions: 1- wire the NICs to sepearte hubs/switches for better redundancy 2: Use the adaptive load balancing/ teaming (with SP5 or greater). The fault tolerant method works but you will have more lag time for the heartbeat check to the other NIC to fail 3: Use two seperate PCI cards if you have the space available (instead of a two NIC on one card). G'Luck! SFO

This discussion is closed to new replies.