Discussion Locked

2 nics, 2 gateways and w2000 routing

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a server with 2 nics one is connected to one(our) network with a gateway 10.1.1.1 and the other connected to an internal dmz 10.0.0.2(this one goes to a load balancing box) both nics have gateways installed. when i ping somrthing on 10.1.1.1 network from the box it works for a period of time and then doesn't. when you look at the routing table you will see that the default gateway jumps from 10.1.1.1 to 10.0.0.2(back and forth) what do i need to do to prevent this from happening. i tried changing the metric of 10.0.0.2 to 2 to see if that helped and it didn't. please help.

5 replies

by saihib

Please see Microsoft Knowledge Base Article Q159168. It is too lengthy to post here but it adresses your situation and provides a fix.

by rvkempen

You can never have two default gateways, this is only done for fault tolerance.
Make your default gateway the one that connects to the internet, and setup a network route for the other one.

Than everything should work fine.

This discussion is closed to new replies.