Discussion Locked

2 nics, tcp only works on one

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 2 nics installed on my system runing Win98SE, a 3com and a Realtek. The problem is that tcp/ip only works under one card, (though it is bound to both and shows up under both in the network properties) yet ipx works fine under both nics. If either nic is removed and tcp re-installed it will work fine with the remaining card. Any possible solutions?

8 replies

by dft3

It could be an ARP problem.

You need to make sure that your subnet mask is correct.

Also, ensure that the default gateways are properly configured.

by dft3

If that isn't it, then download the latest drivers for the card that isn't working and see if that fixes it.

by homeshop

You should have two seperate enteries in the list of protocols. Also does each have different IP numbers? You should be able to ping each, 127.0.0.1 for the one and 127.0.0.2 for the other.

by jkozura

What are you using the nics for? Both should not be on the same network. Each should have it's own entry for each protocol in the network control panel. You should see TCP/IP=>3com, and TCP/IP=>Realtek. Under each on these, you should have unique IPaddresses. A typical application would be for a DSL router, where nic 1 is set to an IP corresponding with the router, and nic 2 is set to an IP corresponding to the internal network. When you say that it is only working on 1 card, do you mean you cannot ping one of the addresses? Try setting one to 192.168.0.1 and the other to 192.168.1.1, then see if you can ping theses addresses. Also win winipcfg and see what it says. Lastly, if there is only one TCP/IP=> entry in the control panel, load the TCP/IP protocol again in the network control panel.
John Kozura IV
IS Manager
AICPA/PDI

This discussion is closed to new replies.