7 replies
by raffi_
You are actually talking about PART of a rule here - the 5-4-3 rule
An Ethernet signal can travel through: a maximum of 5 segments, a maximum of 4 Repeaters/hubs, a maximum of 3 populated segments
(Populated segments have more than 2 nodes connected, un-populated segments have only a node at each end, so a 10baseT-segments is a non-populated segment).
There can be more repeaters/hubs in the complete network, and an Ethernet signal can pass-by more than 4 Repeaters/hubs, as long it does not have to go THROUGH more than 4 Repeaters/hubs.
If these rules are violated, the network becomes unreliable.
Here is a decent link on the subject:
http://webopedia.internet.com/TERM/5/5_4_3_rule.html
Regards
Raffi_
by dhollars
by vinnyd
It means you can not link more then 3 more hubs!
a -- b --- c --- d
a,b,c, & d are hubs. Each one is connected to the other from a crossover cable or port on the hub.
a -- b -- c -- d -- e
a,b,c,d, & e are hubs. This will not work because it breaks the 3 hub rule. Hub e makes four and nothing connected to it will connect to the network.
So the 3 hub rule is never connect more then 3 more hubs.
by dhollars
by gmscne
by dhollars
by dhollars
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending