Question Locked

3Com Courier Modems String Commands

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a pair of 3com courier modems that communicate between a pc and an access control panel over a twisted pair of wires I need to know the string of commands to be programmed into these modems to transmit and recieve the data

8 replies

by charles bundy

What is the model of these 3Com courier modems? If they are connected by a twisted pair it sounds like a short haul setup, which would probably be configured by dip switch :). Or you could be using these in leased/sync mode in which case I found this -

http://facility.unavco.org/kb/getattachment.php?data=MTA4fFVTUl9tb2RlbV9tYW51YWwucGRm

This brings us to what is it you are trying to communicate with, the modems or the security panel at the end of the connection?

by julian98

model 3cp3453,it worked for years but I think I got hit with a surge because its making a strange noise,the computer that runs the access system communicates across the modems to the panel

by robo_dev

What software is being used on the PC?

Are these DSL modems or analog modems? (what model)

Was this working before, or is this a new install?

Just curious, what sort of distance? (sometimes modems are not needed)

by julian98

Its an access control software,It has been working for 3 years but 1 modem took a surge ad started making a strange noise ,the distance is maybe 300feet ,the computer talks to the access control board in the other building

by charles bundy

It should do the trick. These were put in as a short haul solution and are treating that 300 feet of cable as a dedicated line from the telco (except in this case you own the cable :)).

Hope this helps!

This discussion is closed to new replies.