Discussion Locked
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
can u discuss how to setup a router and switch?
1 reply
by joseph moore
Well, the easy way to setup a Cisco router is to boot the router, and if it has no setup on it, you can go into Basic Management setup.
You will be asked:
--- System Configuration Dialog --
Would you like to enter the initial ocnfiguraiton dialog?
[yes/no]
Simply type in a Y, then hit Enter, and that will start it.
Now, the Basic Management Setup only sets up enough connectivity for management of the router. YOu then need to go into Extended Setup to configure the individual interfaces, give them IP addresses, and set up routing and such.
hope this helps
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies