Discussion Locked

access denied for remote users

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Today, my xplex hub was rebooted. My network has dhcp; servers, router have static ip addresses. All inhouse users continued to work normally after the hub reboot. However, users dialing into the network via cisco router had "access denied". This continued for about 1 hour. Nothing other than access denied showed in event viewer. Does any have any suggestions as to what happened?

5 replies

by jason

Make sure that your DHCP Scope does not conflict or overlap with your Pool Addresses on your Cisco Remote Access Router.

This discussion is closed to new replies.