Discussion Locked

Access two network connections at once?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've got a user who uses SAPS95 to link her computer to our server's modem banks, and then uses special link software (RUMBA) and telnet to hook into a customer's secure network system. Normally this computer is linked to our server farm via TCP/IP over an ISDN 128k pipe, WAN. When she wishes to connect to her customer's system, she dials in using SAPS over our network, and our modems create the illusion of a Dial-Up Connection.

While she is connected via this virtual dial-up, she cannot useIE 5.0 to access the internet (through a Raptor firewall at server end). When the "dial-up" connection is broken, IE works fine over the WAN...

We've banged our collective heads against the wall trying to figure out what settings will work. Is this "do-able"?

Any help would be greatly appreciated!

Thanks,
Dan Davis
USFlow Corp.

3 replies

by idtent

Not sure about this but you didn't say that you looked at this, so... If the OS thinks its connected over an illusionary dial up conection IE might be using the dial up configuration and not the LAN, where you probably have the firewall settings configured. Just a thought, or at least where I would start based on what you said. Good Luck

This discussion is closed to new replies.