5 replies
by cg it
by robo_dev
The best answer is to buy an Access Point.
With what you have you could plug the Netgear into one of the Ethernet ports on the Dlink (not the WAN or uplink port) and turn off DHCP in the dlink. This would allow the dlink to work basically as an access point. You would first need to assign a static address to the lan-side of the dlink that is in the same range as the local network defined on you netgear..that way you can make the settings changes without having to readressing the workstation every time. Make sure that the static address that you define is outside the range of DHCP addresses assigned in the netgear.
With the above configuration, your laptop should get it's DHCP/DNS information from the Netgear and will be on the same network subnet.
by spadedmatrix
I would suggest plugging the other 5 machines into the D-link if you have enough ethernet ports. If that's not an option set a static IP on the Dlink that matches the IP granted by the Netgear. Disable the Dlink's firewall feature, as this will only add to the confusion. Make certain that every computer has "File and Printer Sharing for Microsoft Networks" enabled in it's network connection properties.
If this comes to no avail try running the Dlink first (in from modem) then using the Netgear off of one of the ethernet ports making certain to port forward the Netgear so that you can access the other computers on the network without the firewall denying you access.
Good luck.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending