Discussion Locked

accessing the internet one dial-up modem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have one machine (client) running Win2000, and I am running Win98 (host) on another machine. There is a hub where the Win2000 is connected to my machine Win98, but the Win2000 machine cannot dial-up or connect to the internet through the hub. Wecan access each other's hard drives but not share either printers through the hub, although both printers are showing in "Network Neighborhood" folder.

Does anyone have any simple software that works with both operating systems or am I missing something? We set both printers as share, and all hard drives are shared.

We also have an external (Win2000 machine) modem and an internal (Win98 machine) modem.
Both modems work, but only on one machine.

5 replies

by grantcom

More information is probably needed. What protocol TCP\IP, using static IP addresses or DHCP. I assume you did install the printers you are wanting to access (network install to get to the share)on the other machine. As far as Internet Connection Sharing I assume you have run the ICS Wizard. I have better luck setting static IP's. Set the Gateway (host) to something like 192.168.0.1 and set the other to 192.168.0.2 On the client machine in network properties go to the TCP\IP properties and go to Gateway and Add 192.168.0.1 Then go to DNS Configuration and enter the Host name (note this should be the exact ID of the client computer, case sensitive not the host computer ID). In DNS search order add 192.168.0.1

Client: Go to Control Paneland Internet Otions and Connection...set this to never dial a connection and click on Lan Settings and put a check in Automatically Detect Settings.

Host: Control Panel, Internet Options, Connection and set to Always Dial Default Connection. Notethat the host Dial UP Connectoid should be set to auto-dial.

Reboot

This should do it.

by michealirwin

This sounds like what you need is some "proxy" software. A Proxy Server is a program that listens to internet requests on your internal LAN and routes them all out of the modem to the internet. When the answers return it sends them to the appropriate destinations.

For starters, try WinProxy by Ositis software (www.ositis.com) - it should be free for 3 or fewer users. Install it on the machine where the modem works and you can get out to the internet. Run it and configure it - it has lots of help, but, if in doubt, leave it to do its own thing.

Then change your browser to look at the proxy and not the real internet. Search in the configuration for Proxies and set up (for HTTP) the IP address of your machine (192.168.1.25, say) and port 80. Save the change and connect; you should be able to reach the internet again.

Lastly, go to your other machine and configure your browser the same way. If you're lucky it will work immediately; if not, try opening the Properties of Network Neighbourhood and then the Properties of the TCP/IP Protocol. You should find a Gateway setting: set it to the address of the machine with the modems.

It's easier to do than to say ! Good luck !

This discussion is closed to new replies.