Discussion Locked

AD problem over elines

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I have a network of 4 sites linked with e-line (ethernet) with cisco routers on every site. When the pcs from the remote sites try to connect on the DC (2003) on the central site they get the error that domain is not available...and will log you on with your roaming etc. We can ping, tracert, dns, domain everything is ok. VoIP works fine. You can also remove the pc from the domain but you can not join the domain from the sites as we get the error that domain is not available.
We tried everything but its always a dead end. No firewalls or filters are installed anywhere on the sites.

Any suggestions......???

5 replies

by p.j.hutchison

What is the speed of the e-line (ethernet)?
10Mbps? 100Mpbs?
Are all the DCs on the main site or does each site have its own DC? Have you considered putting a DC in its own site?
Does each side have its own subnet?

by mickey6

1.) Are all of the subnet routes on ALL routers set right?

2.) Setup a master set of HOSTS and LMHOST files and get them on all PCs and servers;
on MS in the C:\WINDOWS\system32\drivers\etc directory,
on Linux the /etc directory if the servers are using Samba the /etc/samba directory.

3.) if you can ping a remote router and not the remote server most likly the server is missing a return route or your local router pass thru is not properly set.

this is assuming tcp/ip setup is used of course.

by dixon

...you might need to configure the following GPO:

Computer Configuration\Administrative Templates\System\Logon\Always wait for the network at computer startup and logon

At least, I've had cases where that ended up being the fix. It might, however, make logons painfully slow.

by dixon

...is latency in whatever internet connection you're using. I've had tons of problems in setups like yours where latency was an issue. Do you have full duplex?

This discussion is closed to new replies.