Discussion Locked

Add a new server to a login script

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Compaq Proliant Server running netware 4.11. I recently added a Quantum Snap Server to the network. The server name is imagenw. I need imagenw to be added to the 4.11 login script so that each user sees the new server as a mapped drive.If K: were the next available letter, what would the syntax in the login script be to make this happen?

9 replies

by jimbb

Basically, map k:=server/volume: should do the trick. You can't map to a server only, you need to know the name of the volume.

by drdon

You should be sure that the users have access to the imagenw server. Container login script could be used and then map K:=imagenw\

I also would make sure both servers are in the same container if possible.

by keithpup

I think that it would be easiest to add a line that pionts to next available server instead of a specific letter (thus avoiding mix up over users specific mapping)
Map next imagenw\sys:data or
map k:=imagenw\sys:data

by kevin anderson

These answers are all correct, however they ignore one aspect of this problem.

SnapServers support bindery, but NOT Directory Services.

You will need to create a bindery attachment to the server, as well as creating new user IDs for everyone on the snapserver.

If you run NT on the desktops, and security isn't too much of an issue, you COULD set up 1 ID for everyone, and sign them in with net use k: \\imagenw\volumename /user:xxx password. (I THINK you can, anyway...)

Sorry I didn'thave better news for ya.

Kev.

This discussion is closed to new replies.