Discussion Locked

Add Win2000 server to existing NT domain

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have a new server that is set up with 2000 to replace our old BDC/Applications running NT. Is it possible to add the 2000 server to our existing NT domain without a major problem? Do they have to be the same OS? We received an error window indicating that "The domain "our domain name" is not an Active Directory domain or an Active Directory domain controller could not be contacted".

8 replies

by curlergirl

You can add a Win2K server to an existing NT domain, but you cannot implement Active Directory one your Win2K machine, because NT 4.0 cannot communicate with the Win2K Active Directory components. I'm not sure, but I don't think a Win2K DC can act as a BDC for an NT domain - maybe someone else has experience w/this, but I don't.

by curlergirl

To clarify my comment about not acting as a BDC, my reading and (small) experience indicates that Microsoft's recommended configuration is to set up the Win2K server as a member server, not a BDC. Good luck!

by duskos

Actually, you can add your Win 2000 server as a domain controller (DC) to your network, but in that case Win2000 server becomes the "master" DC on yor network.

I have done it and it worked for me, maybe it will work for you as well.

Step 1
Install Windows NT 4.0 with Service Pack 6a to your new server. Chose to configure this server as a backup domain controller (BDC).

Step 2
Promote your new NT server to become Primary Domain Controller (PDC).

Step 3
Upgrade your new NT 4.0 PDC server to Windows 2000 server. Your new Win 2000 server will become the Active Directory Controller for your network. Your old BDC's will work with no problem as BDC's, but you'll not be able to make them PDC's again as long as you have Win2000 DC's.
Install Windows 2000 Service Pack 1 as well.

Step 4
Upgrade your existing NT 4.0 BDC's to Win 2000. When you upgrade the last NT 4.0 BDC, you can switch your Windows 2000 domain to native mode which gives you more options with configuring your domain. When you upgrade NT 4.0 BDC's to Win2000, you don't need to make them all domain controllers.

by mary.schingeck

I'll keep your steps available when we need to upgrade our pdc. Right now we set the new server as a member only and so far it's working for our users. We had no space and needed to do something asap.

by tony.colgrove

As long as you dont want to setup Active Directory, you should have no issues adding the server as a member server. Win2K cannot function as a BDC in an NT4 domain, it must run Active directory if it is configured as a Domain Controller.
Answer two does step you through making this server into a AD server, but one note: You must use DNS with AD, which might take a little extra knowledge if you havent setup DNS before.

This discussion is closed to new replies.