Discussion Locked

Adding a new network card to a domain

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hello all, I was wondering if anyone can help me find some info or tutorials on adding a new PC/NIC card onto an NT Domain, Particulary all the neccesary steps involved start to finish. Thanks guys (and gals)

7 replies

by bohicam1

I am assuming that you already have the machine running on the network and you would just like to replace the nic?
Simply install the new card in the same slot the old one was and install the drivers, usually a floppy that comes with the new nic card.
Good luck!

Mike

by dano1971

Hey Mike, Actually what I am looking for is info on adding a brand new machine out of the box to an existing network, including installing the NIC card and its drivers and verifying its communication on the network

by rkirtz

there will be a blue cord called an ethernet
cable plug it in and plug all the existing power cords in. Find out what domain you
want this computer in, turn the computer on
click on network properties and change this
computer's name to a unique name not already
on the domain, restart, your computer. When
Windows boots up again change the domain you
want your computer to be on, you may need to ask your administrator what the login and pass are and check the box for create account right above name and passwd (in network neighborhood, properties, identification tab) once you have changed the domain and clicked OK it should say successfully added to the domain, restart you computer again, and as my boss would say
you are good to go.....

by bohicam1

ok then dano, in that case since it is new and out of the box, chances are that it won't have NT installed on it. In that case, open up the case and put the nic card into it into one of the slots if it doesn't come with one.
For PCI cards, it wouldbe a white slot(most are PCI). Since it is a new machine there is probably an operating system on it so you would format the machine first with a floppy. Insert a dos diskette and at the A:\ prompt, type format /s depending on the hard drive, you might have to "fdisk" first. I hope you know your way around this, if not, just email me. Create a partition of about one gig or less( no less than 500MB though). When you start the machine go into the bios and make sure that the first boot drive is cdrom. insert the cd into the tray and let it run. During the install it will ask for the nic card identification and you choose "have disk", then you insert the floppy and click ok, it will install the drivers for you. soon after, it will ask you to configure the network settings, just put in the name of the network and create the account on the server and you are set.
Good luck!

Mike

This discussion is closed to new replies.