Discussion Locked

Adding another HD for Netware v4.1

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Added another Hard Drive to a Netware v4.1 Server. I can see the other drive "D:" in DOS but can't seem to see it in Netware. Any Ideas WHY??

Darryl

7 replies

by drdon

In Install can you see the new disk? You will need to create a Netware Partion and then assign the space to teh volumes. You also can check on the Monitor Console for the Device and make sure the OS knows about the existance of the drive. I am ofcourse, reading this as it is not in a hardware RAID configuration.

If it is a hardware RAID, you will need to follow the RAID card instructions for adding a drive to an exisiting array.

Hope this helps

by mr_cellophane

1
At the server console prompt, type
LOAD INSTALL
2
Select "Disk Options" from "Installation Options" menu.
3
Select "Modify Disk Partitions" from the "Available Disk Options" menu.
If you have more than one disk, the "Available Disk Drives" list appears. If this list appears, select the disk you want to partition.
A list of existing partitions appears, along with the "Disk Partition Options" menu.
4
Select "Create NetWare Disk Partition" from the "Disk Partition Options" menu.
NetWare allows only one NetWare partition per disk (unless the machine vendor presents multiple hard drives as one logical drive). If the disk has more than one free partition area, select an area for the NetWare partition.
A screen containing disk partition and Hot Fix information with their default values appears. The cursor is on the "Partition Size" field.
5
If you don't want to use the whole partition for NetWare, type a smaller value in the "Partition Size" field.
The difference between theoriginal size and the smaller size is added to the free space on the disk.
6
To change the size of the data area, use the arrow keys to move the cursor to one of the "Data Area" fields, and then type in a new value.
One field contains the size ofthe data area in blocks, the other in megabytes. When you change the value in one field, the system changes the corresponding value in the other field.
7
To change the size of the Hot Fix Redirection Area, use the arrow keys to move the cursor to one of the "Hot Fix Redirection Area" fields, and then type in a new value.
One field contains the size of the area in blocks, the other as a percentage of the partition. When you change the value in one field, the system changes the corresponding value in the other field.
8
ESC to display the "Create NetWare Partition?" window.
9
Select "Yes"
10
ESC twice to redisplay the "Available Disk Options" menu.
11
ESC to exit.

by isys

Use FDISK to make sure there are no existing partitions on the disk. Then use the procedure above (Load Install, etc.).

This discussion is closed to new replies.